GRAPHTEC CE LITE-50 - Adjusting Cutting Time, Speed, and Acceleration

5-7
Chapter 5 Detailed Settings
5.3 Adjusting the Cutting Time
7KHFXWWLQJWLPHFDQEHDGMXVWHGE\VHWWLQJWKHFXWWLQJVSHHGVSHHGZKHQVWDUWLQJWKHFXWDFFHOHUDWLRQ
and "moving speed when the tool is lifted".
$VVHWWLQJDVSHHGWKDWLVWRRIDVWFDQDIIHFWWKHFXWWLQJTXDOLW\VHWYDOXHVWKDWVXLWWKHW\SHRIWRRODQGPHGLD
WREHXVHG
2QFH\RXDUHGRQHZLWKWKHVHWWLQJVWRXFKWKH
([LWWRUHWXUQWRWKH+20(VFUHHQ
Setting the Speed
6HWWKHFXWWLQJVSHHG
$OWKRXJKVHWWLQJDIDVWHUVSHHGZLOOVKRUWHQWKHFXWWLQJWLPHGRLQJVRPD\DOVRORZHUWKHTXDOLW\RIWKHÀQLVK
&RQÀJXUDEOHYDOXHV
1. Touch the &21',7,21RQWKH
+20(VFUHHQWRRSHQWKH&21',7,21
12VHWWLQJVFUHHQ
2. 6HOHFWWKH&21',7,2112WRVHWE\XVLQJ
the "
" and " DQGWRXFKWKH63(('
3. 8VHWKH " and " " to select the speed
DQGFRQÀUPWKHVHOHFWLRQZLWKWKH
&RQÀUP
Setting the Acceleration
6HWWKHDFFHOHUDWLRQ7KLVVHWWLQJLVDSSOLHGWRDOORSHUDWLRQVZKHQVWDUWLQJWKHFXWDIWHUWKHWRROKDVEHHQORZHUHG
$OWKRXJKVHWWLQJDJUHDWHUYDOXHZLOOVKRUWHQWKHFXWWLQJWLPHGRLQJVRPD\DOVRORZHUWKHTXDOLW\RIWKHÀQLVK
&RQÀJXUDEOHUDQJH
1. Touch the &21',7,21RQWKH
+20(VFUHHQWRRSHQWKH&21',7,21
12VHWWLQJVFUHHQ
2. 6HOHFWWKH&21',7,2112WRVHWE\
using the "
" and " " and touch the
$&&(/(5$7,21
3. 8VHWKH " and " " to select the
DFFHOHUDWLRQDQGFRQÀUPWKHVHOHFWLRQZLWK
the
&RQÀUP