GRAPHTEC Cutting PRO FC2230 Series - Page 8

5. DISASSEMBLY AND ADJUSTMENT
5.1 Adjusting the X-Axis Driver 5-1
5.1.1 Removing the X Motor Cover 5-1
5.1.2 Adjusting the X Drive Belt Tension 5-1
5.1.3 Adjusting the Belt Tension of the Front X Slider 5-2
5.1.4 Adjusting the Belt Tension of the Rear X Slider 5-2
5.1.5 Checking the Belt Tension of the Front and Rear X Slider 5-3
5.2 Adjusting the Y-Axis Driver 5-4
5.2.1 Removing the Y Motor Cover 5-4
5.2.2 Removing the Y Motor 5-4
5.2.3 Adjusting the Y Drive Belt Tension 5-6
5.3 Adjusting the Y Slider 5-7
5.3.1 Removing the Y Bar 5-7
5.3.2 Adjusting the Y Slider Belt Tension 5-8
5.4 Adjusting the Roller Pressure of the Front X Slider 5-10
5.5 Adjusting the Roller Pressure of the Rear X Slider 5-11
5.6 Adjusting the Roller Pressure of the Y Slider 5-13
5.7 Adjusting the Position of Sensor Dog Y 5-14
5.8 Mounting the Y Slider on the Y Flexible Printed Circuit Cable 5-15
5.9 Pen Block(One-Pen Specifications) 5-16
5.9.1 Removing the Pen Block Cover 5-16
5.9.2 Removing the Pen Block 5-16
5.9.3 Adjusting the Pen Block 5-17
5.10 Pen Block(Two-Pen Specifications) 5-19
5.10.1 Removing the Pen Block Cover 5-19
5.10.2 Removing the Pen Block 5-19
5.10.3 Adjusting the Pen Block 5-20
5.11 Using the Mechanical Adjustment Jigs 5-22
5.12 Replacing the Y Bar 5-23
5.12.1 Preparations 5-23
5.12.2 Replaceing the Y Bar 5-23
5.12.3 Checking the Sliding of the Y Bar Frame (Manual Check) 5-24
5.13 Adjusting the Perpendicularity Precision 5-25
5.13.1 Checking the Deviation in the Perpendicularity 5-25
5.14 Replacing the Electrostatic Adhesion Plate 5-27
5.14.1 Peeling Off the Electrostatic Adhesion Plate 5-27
5.14.2 Preliminary Preparations for Pasting On New Plate 5-27
5.14.3 Attaching the Electrostatic Adhesion Plate 5-29
FC2230-UM251-01-1600 vii