Need help?Do you have a question about the GRAPHTEC Cutting PRO FC2231-90ES and is the answer not in the manual?
Provides essential safety guidelines and precautions for operating the plotter.
Explains the layout and functionality of the plotter's control panel.
Step-by-step guide on how to install the cutter pen correctly.
Instructions for setting the appropriate height of the pen carriage.
Addresses issues where the plotter does not operate after power on.
Lists common error messages and their potential causes and solutions.
Provides solutions for common problems affecting cutting quality.
Detailed steps for adjusting various parts of the X-axis driver.
Detailed steps for adjusting various parts of the Y-axis driver.
Procedures for adjusting the Y slider and its belt tension.
Instructions for safely replacing the Y bar.
Flowchart to diagnose and resolve issues with blade rotation.
Flowcharts to address problems with cutting media quality.
Flowchart for troubleshooting abnormal plotter initialization.
Flowcharts to resolve issues with pen movement.
Diagnosing and fixing excessive backlash in the X-axis.
Diagnosing and fixing excessive backlash in the Y-axis.
Outlines the sequence for performing electrical adjustments.
Explains DIP switch settings for different operational modes.
Step-by-step guide to clear the plotter's non-volatile RAM.
Guides on setting default trimmer positions on the main board.
Procedure for adjusting motor offset values for X and Y axes.
Instructions for setting the pen offset to ensure accurate positioning.
Details on how to adjust the pen servo for precise movement.
Guide on how to adjust the force applied by the cutter or pen.
To Next Page
General