GRAPHTEC FC7000-75 - Assembling the Plotter

FC7000-UM-251-9370 2-3
2. PARTS NAMES and FUNCTIONS
2.2 Assembling the Plotter
FC7000-75 (desktop model; stand not provided but is available as an option)
When the FC7000-75 is used without a stand, the media stocker bracket is attached directly to the plotter.
The media stocker is made up of the following parts.
Stock roller x 2Media stocker bracket x 2 M4 binding-head screw x 4
ATTACHING THE MEDIA STOCKER
(1) Fasten the media stocker brackets to the left and right inside surfaces of the plotter unit, using two M4
binding-head screws for each media stocker bracket.
(2) Insert an M4 screw in the second hole from the front side of the plotter.
• Check that all of the screws used for fastening have been tightened. The media
may not be fed correctly if even one of the screws is loose.
• When installing the plotter, make sure that there are no objects in its vicinity.
Leave a clear space of at least 300 mm around the plotter.
• When the FC7000-75 is used without a stand, the maximum diameter of the roll
media that can be used is 160 mm.