Need help?Do you have a question about the GRAPHTEC FC8000-75 and is the answer not in the manual?
General| Model | FC8000-75 |
|---|---|
| Category | Plotter |
| Drive Method | Servo Motor |
| Maximum Cutting Width | 750 mm |
| Maximum Media Width | 800 mm |
| Maximum Cutting Area | 750 mm x 50 m |
| Repeatability | ±0.1 mm |
| Interface | USB, Serial |
| Supported OS | Windows, Mac OS |
| Cutting Force | 500 gf |
| Programmable Resolution | 0.025 mm |
| Media Type | Vinyl, Paper, Cardboard, etc. |
| Command Sets | HP-GL, GP-GL |
| Power Supply | AC 100-240 V, 50/60 Hz |
| Dimensions | 800 mm x 400 mm x 200 mm |
| Weight | 60 kg |
| Configuration | Standalone |
Details core technical specifications of the FC8000 plotter.
Identifies and describes key external components of the cutting plotter.
Details the functions of the keys and lamps on the plotter's control panel.
Details the disassembly and reassembly of various mechanical components within the plotter.
Lists components needing readjustment after replacement or sensor alteration.
Details electrical adjustments including DIP switch settings and menu calibrations.
Troubleshoots issues when the plotter fails to turn on or display.
Troubleshoots problems with media feeding, alignment, and sensor detection.
Addresses issues with cut line crookedness, blade skipping, and shifted positions.
Lists and explains various error codes encountered during plotter operation.
To Next Page