Need help?Do you have a question about the GRAPHTEC FC4200-60 and is the answer not in the manual?
Verify that all standard accessories are present after unpacking the plotter.
Identifies and explains the function of each part of the plotter.
Details the different cutter blades available and their specific applications.
Illustrates and names the components of the cutter pen plunger system.
Step-by-step procedure for safely replacing a cutter blade.
Guide to correctly setting the cutter blade extension for different media.
Overview of the plotter's control panel, including indicator lamps and function keys.
Visual representation of the plotter's menu navigation system.
Instructions for establishing a connection via serial or parallel interfaces.
Procedure for powering on the plotter and its initialization sequence.
Methods for properly loading and securing media onto the plotter's writing panel.
Details optimum cutting conditions based on media type, blade, force, speed, and quality.
How to select and register predefined cutting condition sets.
Guide to setting parameters like FORCE, SPEED, OFFSET, and QUALITY.
Procedure for performing test cuts to verify and optimize settings.
How to set a new starting position for cutting or plotting operations.
Repeats a cutting operation using data stored in the plotter's buffer memory.
Adjusts pen positions to correct deviations between cutter and plotter pens.
Controls the pen's UP/DOWN movement for cutting and plotting.
Deletes cutting data saved in the plotter's internal buffer memory.
Assigns four sets of pen conditions to pen holders 1 and 2.
Sets the origin point to bottom left or center in HP-GL command mode.
Defines the active area for cutting or plotting by specifying corner points.
Activates the ROTATE mode to change the image's orientation.
Configures settings for cutting thick or stiff media.
Activates the MIRROR mode to reverse the coordinate system for mirror images.
Optimizes pen changes by sorting plotting data for efficiency.
Explains principles and requirements for automatic registration mark reading.
Aligns plotter axes with medium's coordinate axes using registration marks.
Chooses the specific registration mark pattern to be used for recognition.
Sets the physical dimensions of registration marks for accurate detection.
Adjusts distance precision, sensor, and offset for registration marks. Includes 6.11.1-6.11.4.
Adjusts the travel speed of the pen when it is in the raised (UP) position.
Specifies cutting pressure for initial blade control during media cutting.
Sets a reference angle for initial blade control to optimize cutting time.
Defines the minimum distance unit for processing short-distance coordinate points.
Switches the display of coordinate values between millimeters and inches.
Corrects deviations in line segment lengths during cutting or plotting.
Explains various special functions like command handling and mode settings.
Procedure for enabling or disabling special functions via plotter menus.
Guides on printing conditions, running self-tests, and character dump mode.
Provides solutions for common issues like plotter not operating or unsatisfactory results.
Lists and explains various error messages and their causes/solutions.
Configuration steps for using the parallel interface connection.
Configuration steps for using the serial interface connection.
Sets the minimum distance unit for pen movement in GP-GL mode.
Configures serial interface parameters like baud rate, data length, and parity.
Sets the plotter to use either GP-GL or HP-GL command modes.
Lists technical specifications for FC4200-50 and FC4200-60 models.
Details available optional accessories for the plotter.
Provides dimensional drawings and measurements for the plotter models.
To Next Page
General