Need help?Do you have a question about the GRAPHTEC FC8600-60 and is the answer not in the manual?
Details the technical specifications of the cutting plotter models.
Explains the functions of buttons, lamps, and indicators on the control panel.
Procedures for removing and reinstalling external covers and panels.
Procedures for removing and reinstalling various mechanical components.
Procedure to set proper tension on the Y-axis belt for performance.
Steps to adjust the tension of the Y-drive belt for optimal performance.
Procedure to adjust the tension of the X-drive belt for optimal performance.
How to measure and adjust the force of the pinch rollers.
Procedure to clear NOV-RAM when replacing the main board.
Procedure to set the pen force for different pen types and conditions.
Procedure to calibrate and set the plotter's distance accuracy.
Calibrating the sensitivity of the registration mark sensor.
Procedure to adjust the offset for the auto-registration mark sensor.
Setting the home position value for the cross cutter.
Procedure for updating the plotter's system firmware using a computer.
Troubleshooting steps when the plotter does not turn on or display anything.
Diagnosing and fixing problems with media loading and sensor detection.
Troubleshooting common problems during cutting operations.
List and explanation of hardware-related error codes and their solutions.
Explanation of error codes related to the Automatic Registration Mark Sensor (ARMS).
Checks sensor status and control panel switch functionality.
Performing a self-diagnostic test of sensors and switches.
To Next Page
General