GRAPHTEC FC8600-60 - GP-GL Command Mode Error Messages

FC8600-UM-251-9370 8-6
8 TROUBLESHOOTING
8.4.2 Error Messages in GP-GL Command Mode
Error
code
Error Display Cause Verication item Solution
E02001
The plotter received
an unrecognizable
command.
(1) Did the plotter
receive an
unrecognizable
command?
No .....Verify item (2)
Yes ....Send correct data
to plotter.
(2) Is there any
noise on the
line?
No .....Verify item (3)
Yes ....Check the
interface cable
or move the
plotter to another
location.
(3) Has the correct
model name
been set for the
plotter?
No .....Set the correct
model name.
Congure your software
application menu to
permit Graphtec plotter
control. Re-specify the
software application’s
interface conditions.
E02004
The software
conguration
regarding the output
device has been
changed.
The plotter’s interface
conditions have been
changed.
The numeric
parameter of an input
command exceeds its
permissible range.
Congure your software
application menu to
permit Graphtec plotter
control. Re-specify the
software application’s
interface conditions.
Set the correct model
name if it was incorrect.
E02005