GRAPHTEC FC8000-75 - Error Messages in HP-GL Emulation Mode

FC8000-UM-251-9370 8-8
8. TROUBLESHOOTING
8.4.3 Error Messages in HP-GL Emulation Mode
Ifanyofthefollowingcommanderrorsoccur,theyarenearlyalwayscausedbyoneofthereasonsbelow:
(1) Thesoftwarecongurationregardingtheoutputdevicehasbeenchanged;or
(2) Theplotter’sinterfaceconditionshavebeenchanged.
WhenacommanderroroccursinHP-GL
TM
emulationmode,therefore,rstcheckthetwocorresponding
pointsbelow:
(1) Congurethesoftwaretodriveyourplotter,andensurethatthesoftware’sinterfaceconditionsare
correctlyset;and
(2) Ensurethattheplotter’sinterfaceconditionsaresettomatchthoseofthesoftware.
Error
code
Error Display Cause Verication item Solution
E03001
E03001 HP-GL
ERROR 1
INSTRUCTION
NOT RECOGNIZED
E CONFIRM
Anunrecognizable
instructionwas
executed.
Executea
recognizable
command.
(1) Didtheplotter
receivean
unrecognizable
command?
No.....Verifyitem(2)
Yes....Sendcorrectdata
toplotter.
(2) Isthereanynoise
ontheline?
No.....Verifyitem(3)
Yes....Checkthe
interfacecableor
movetheplotterto
anotherlocation.
(3) Hasthecorrect
modelnamebeen
setfortheplotter?
No.....Verifyitem(3)
Yes....Checkthe
interfacecableor
movetheplotterto
anotherlocation.
No.....Setthecorrect
modelname.
Congureyoursoftware
applicationmenuto
permitGraphtecplotter
control.Re-specifythe
softwareapplication’s
interfaceconditions.