GRAPHTEC FC8000-75 - Upgrading the System Firmware

FC8000-UM-251-9370 7-34
7. ADJUSTMENT
7.4 Upgrading the System Firmware
Toupgradethesystemrmwareyouneedtohavethefollowingles.Inaddition,youneedtouseacomputer
andUSBcable.
•FC8000_V***.X :FC8000rmware
•SEND.EXE :UtilitytotransferlesusingWindows
®
•OPS662 :USBDriversoftwarefortheFC8000
Preparation
InstalltheUSBDriversoftwaretoyourcomputerbeforeupgradingthesystemrmware.
How to upgrade the system rmware
(1) ConnectthecomputerandtheplotterviatheUSBinterface.
(2) Loadasheetofpaperintheplotter.
(3) TurnonthepowerwhilepressingtheLEFTARROWandRIGHTARROWkeys.
Or
Afterturningonthepower,presstheLEFTARROWkeyandtheRIGHTARROWkeysimultaneously
within2seconds.
(4) Theplotterdisplaysthemenushownbelow.
UPDATE ? No
(5) Select“Yes”usingtheUPARROWorDOWNARROWkey.
UPDATE ? Yes
(6) PresstheENTERkeytodisplaythemenushownbelow.
PLEASE SEND PRG.
(7) Sendrmwaretotheplotterfromthecomputer.
ExecuteSEND.EXE.
SelectthesystemrmwarelefromtheSEND.EXEmenu.
OutputthesystemrmwareletotheFC8000.
(8) Thefollowingmenuisdisplayedwhiledataisbeingreceived.
**KB RECEIVED
(9) Theplotterwillstarttheinitializationroutinewhenallthedatahasbeenreceived.Thermwareversion
isdisplayedduringtheinitializationroutine.Checkthermwareversionthatyouupgraded.
(10) Turnoffthepower.