GRAPHTEC FC8000-75 - Error Messages in GP-GL Command Mode

FC8000-UM-251-9370 8-7
8. TROUBLESHOOTING
8.4.2 Error Messages in GP-GL Command Mode
Error
code
Error Display Cause Verication item Solution
E02001
E02001 GP-GL
ERROR 1
COMMAND ERROR!
E CONFIRM
Theplotter
receivedan
unrecognizable
command.
(1) Didtheplotter
receivean
unrecognizable
command?
No.....Verifyitem(2)
Yes....Sendcorrectdata
toplotter.
(2) Isthereanynoise
ontheline?
No.....Verifyitem(3)
Yes....Checkthe
interfacecableor
movetheplotterto
anotherlocation.
(3) Hasthecorrect
modelnamebeen
setfortheplotter?
No.....Setthecorrect
modelname.
Congureyoursoftware
applicationmenuto
permitGraphtecplotter
control.Re-specifythe
softwareapplication’s
interfaceconditions.
E02004
E02004 GP-GL
ERROR 4
PARAMETER OVERFLOW!
E CONFIRM
•Thesoftware
conguration
regardingthe
outputdevice
hasbeen
changed.
•Theplotter’s
interface
conditions
havebeen
changed.
Thenumericparameter
ofaninputcommand
exceedsitspermissible
range.
Congureyoursoftware
applicationmenuto
permitGraphtecplotter
control.Re-specifythe
softwareapplication’s
interfaceconditions.
Setthecorrectmodel
nameifitwasincorrect.
E02005
E02005 GP-GL
ERROR 5
I/O ERROR!
E CONFIRM
Anerrorrelatedtothe
receiptofdataoccurred
withintheinterface.