GRAPHTEC FC8000-75 - Warning Messages

FC8000-UM-251-9370 8-15
8. TROUBLESHOOTING
8.4.6 Warning Messages
Error
code
Error Display Cause Solution
W06001
W06001 WARNING
CROSS CUT
SHEET
Crosscutfunctioncannotbeused
forsheetmedia.
Userollmedia.
W06002
W06002 WARNING
CROSS CUT
FRONT
E CONFIRM
Crosscutfunctioncannotbeused
becausethemediaisloadedfrom
thefront.
Loadthemediafromtherear.
W06003
W06003 WARNING
CROSS CUT
LOAD MEDIA
Crosscutfunctioncannotbeused
untilthemediasizeisdetected.
Loadthemedia.
W06004
W06004 WARNING
CROSS CUT
PUSH ROLLER SENSOR
DISABLED
Crosscutfunctioncannotbeused
whenthepushrollersensoris
disabled.
Enablethepushrollersensor.
W06005
W06005 WARNING
CROSS CUT
MEDIA SENSOR
DISABLED
Crosscutfunctioncannotbe
usedwhenthemediasensoris
disabled.
Enablethemediasensor.
W06006
W06006 WARNING
TOOL=POUNCE
CONDITIONNo.thathasselected
pouncingtoolasthetoolnumber
settingcanonlysetTOOL1.
SelectTOOL1.