Need help?Do you have a question about the GRAPHTEC FC7000-130 and is the answer not in the manual?
General| Model | FC7000-130 |
|---|---|
| Category | Plotter |
| Type | Cutting Plotter |
| Drive Method | Servo Motor |
| Max Cutting Width/Area | 1300 mm |
| Max Cutting Speed | 1000 mm/s |
| Mechanical Resolution | 0.025 mm |
| Repeatability | ±0.1 mm |
| Number of Tool Mounts | 2 |
| Media Hold-Down Method | Vacuum |
| Power Consumption | 150 W |
| Interface | USB |
| Command Sets | HP-GL |
| Power Supply | AC 100-240V, 50/60Hz |
| Operating Environment | Temperature: 10-35°C, Humidity: 35-80% RH |
| Configuration | Standalone |
Detailed specifications for the FC7000 and FC7000MK2 series plotters.
Physical dimensions of the plotter models, including with and without stand.
Identifies and describes the main components of the plotter (front and rear views).
Instructions for assembling the plotter and its accessories like the media stocker.
Steps to attach the optional FC7000 basket to the plotter stand.
Procedure for mounting cutter pens into the plotter's pen holder.
Step-by-step guide for safely replacing the cross-cutter unit.
Explanation of the plotter's control panel buttons, indicators, and functions.
Overview of the plotter's menu structure and navigation paths.
Explains various background settings and their specific functions.
Step-by-step guide to configure background settings on the plotter.
Procedures for removing and replacing the plotter's external covers.
Steps for disassembling and reassembling key mechanical components.
Identifies components needing readjustment after replacement or alteration.
Detailed procedures for mechanical adjustments like belt tension and roller pressure.
Procedures for electrical adjustments, DIP switch settings, and voltage checks.
Checks the status and functionality of the plotter's various sensors.
Tests the functionality and status of the control panel's switches.
Solves issues where the plotter does not power on or display anything.
Addresses problems related to media feeding, loading, and recognition.
Troubleshoots issues encountered during cutting operations like crooked lines.
Explains and provides solutions for various hardware and command error messages.
Lists parts related to the plotter's external housing and covers.
Lists components of the plotter's control panel assembly.
Lists parts associated with the pen block assembly.
Lists components of the plotter's main structural frame.
Lists parts for the Y-axis rail system.
Lists parts for the Y-axis slider mechanism.
Lists various wiring harnesses and cables used in the plotter.
Lists identification and warning labels for the plotter.
Lists parts for the media stocker and stand accessories.
Lists parts for the optional basket accessory.
Lists standard accessories and packing boxes.
High-level overview of the plotter's functional blocks for FC7000 and FC7000MK2.
Detailed electrical circuit schematics for various components and boards.
Circuit diagram of the main board's top section.
Circuit diagram for the connector block 1 on the main board.
Circuit diagram for another connector block on the main board.
Circuit diagram of the CPU block on the main board.
Circuit diagram for the DC driver section of the main board.
Circuit diagram of the interface (I/F) block on the main board.
Circuit diagram of the GRC servo block on the main board.
Circuit diagram of the memory block on the main board.
Circuit diagram of the USB block on the main board.
Circuit diagram for the control board.
Circuit diagrams for relay, pinch roller sensor, and RMS boards.
Circuit diagrams specifically for the FC7000MK2 main board.
To Next Page