GRAPHTEC FC7000-130 - How to Replace the Pinch Roller Sensor

FC7000-UM-251-9370 6-17
6. DISASSEMBLY AND REASSEMBLY
6.2.7 How to Replace the Pinch Roller Sensor
How to detach the pinch roller sensor
(1) Detach the center cover (see Subsection 6.1.3).
(2) Detach the pen block (see Subsection 6.2.5).
(3) Disconnect the pinch roller fl exible cable from the Y-relay board.
(4) Remove the pinch roller fl exible cable that is attached with double-sided adhesive tape to the Y-slider.
(5) Remove the M3L6 binding head screw attaching the pinch roller sensor bracket to the slider.
Y slider
M3L6 binding head screw
Pinch roller sensor bracket
Pinch roller sensor board
(6) Remove the two M3L6 binding head screws attaching the pinch roller sensor guard.
Pinch roller sensor guard
M3L6 binding head screw
Pinch roller sensor bracket
Pinch roller sensor board
(7) Remove the M3L6 binding head screw attaching the pinch roller sensor board.
M3L6 binding head screw
Pinch roller sensor bracketPinch roller sensor board
(8) Disconnect the pinch roller fl exible cable from the pinch roller sensor board.