GRAPHTEC FC7000-130 - Replacing the Cross-Cutter Unit

FC7000-UM-251-9370 2-12
2. PARTS NAMES and FUNCTIONS
2.5 Replacing the Cross-Cutter Unit
Follow the procedure below to replace the cross-cutter unit that is used to cut the media after the plotting or
cutting operation has been completed.
(1) Check that the power switch is turned off (the “O“ side is pressed down).
(2) Remove the screw holding the cross-cutter unit in place, and then remove the cross-cutter unit.
Cross-cutter unit
(3) Remove the protective cover from the replacement cross-cutter unit. Be sure to remove the protective
cover while holding the part of the unit shown in the figure below.
Protective cover
(4) Attach the replacement cross-cutter unit, and tighten the screw to hold it in place.
Cross-cutter unit
WARNING: The cross-cutter unit uses a very sharp blade. Take care not to cut
yourself on the blade.