GRAPHTEC FC7000-130 - Setting the Background Settings

FC7000-UM-251-9370 3-8
3. OPERATIONS
3.4 Setting the Background Settings
SETTING PROCEDURE
(1) Use the following procedure to display the background setting menus.
Load media in the plotter, and then turn on the power. Press the MENU key and then press the NEXT
key until the following menu appears.
PEN UP/DOWN>
BACKGROUND SETTINGS>
OPTION 1>
OPTION 2>
Press the F2 key (BACKGROUND SETTINGS) to enter the setting mode.
(2) Press the NEXT key to move through the BACKGROUND SETTINGS menus in the displayed sequence.
GP-GL
Background Settings
*2-Pen Model
*2-Pen Model
*2-Pen Model
*2-Pen Model
LANGUAGE SELECTION
[ JA
PANESE ]
COMMAND ;
AND :
ENABLE
D *
DISABLED
"W" COMMAND
PEN U
P
PEN DOW
N*
CONDITION PRIORITY
MANUA
L*
PROGRAM
INITIA
L BLADE
CONTRO
L POSITION
2mm BELOW *
OUTSIDE
LENGTH UNI
T
INCH
METRIC*
PEN U
P MOVE
ENABLE
D *
DISABLED
MEDIA SENSOR
ENABLED
*
DISABLED
PINCH ROLLER SENSOR
ENABLED
*
DISABLED
CROSS CUT PRESSURE
30
CHECK PEN
ENABLED
*
DISABLED
FAN POWER
WEAK
NORMAL*
BEEP
FOR KEY OPERATION
OFF
ON*
MARK AUTO SCAN
ON
OF F *
LANGUAGE SELECTION
[ JA
PANESE ]
MODEL EMULATED
7550*
7586
CONDITION PRIORITY
MANUAL*
PROGRAM
PEN SELECT
ENABLE
D*
DISABLED
PEN SELECT
ENABLED
DISABLED
INITIA
L BLADE
CONTRO
L POSITION
2mm BELOW*
OUTSIDE
LENGTH UNI
T
INCH
METRIC
*
PEN U
P MOVE
ENABLED
DISABLED
*
MEDI
A SENSOR
ENABLE
D*
DISABLED
PINCH ROLLER SENSOR
ENABLE
D*
DISABLED
CIRCLE RESOLUTION
AU
TO
DE
FAULT*
CROSS CUT PRESSURE
30
CHECK PEN
ENABLED
*
DISABLED
FAN POWER
WEAK
NORMAL*
BEEP
FOR KEY OPERATION
OFF
ON*
MARK AUTO SCAN
ON
OF F*
HP-GL
TM
Background Settings
(3) At the LANGUAGE SELECTION menu, use the ( ) POSITION keys to select the desired language
and then press the ENTER key.
At the CROSS CUT PRESSURE menu, use the ( ) POSITION keys to increase or decrease the value
and then press the ENTER key.