GRAPHTEC FC7000-130 - Clearing the Non-Volatile RAM

FC7000-UM-251-9370 7-12
7. ADJUSTMENT
7.3.5 Clearing the Non-Volatile RAM
When you replace the main board, you must clear the Non-Volatile RAM (NOV-RAM).
If you clear the Non-Volatile RAM, you will lose the setup parameters for each adjustment.
Input the adjustment values to the main board after you clear the Non-Volatile RAM.
How to clear the Non-Volatile RAM.
(1) Set SW1 to the NOV-RAM clear mode as shown below.
FC7000MK2-60 FC7000MK2-60 (2-Pen Model)
SW1
1 2 3 4 5 6 7 8
ON
OFF
SW1
1 2 3 4 5 6 7 8
ON
OFF
FC7000-75/MK2-75 FC7000-75/MK2-75 (2-Pen Model)
SW1
1 2 3 4 5 6 7 8
ON
OFF
SW1
1 2 3 4 5 6 7 8
ON
OFF
FC7000-100/MK2-100 FC7000-100/MK2-100 (2-Pen Model)
SW1
1 2 3 4 5 6 7 8
ON
OFF
SW1
1 2 3 4 5 6 7 8
ON
OFF
FC7000-130/MK2-130 FC7000-130/MK2-130 (2-Pen Model)
SW1
1 2 3 4 5 6 7 8
ON
OFF
SW1
1 2 3 4 5 6 7 8
ON
OFF
FC7000-160/MK2-160 FC7000-160/MK2-160 (2-Pen Model)
SW1
1 2 3 4 5 6 7 8
ON
OFF
SW1
1 2 3 4 5 6 7 8
ON
OFF
(2) Turn on the power to the plotter.
(3) The NOVRAM CLEAR START menu appears. The plotter immediately starts to clear the parameters on
the NOV-RAM, and then sets the default values.
NOVRAM CLEAR START
(4) When the programming is complete, the NOVRAM CLEAR END menu appears.
NOVRAM CLEAR END
(5) Turn off the power to the plotter.