GRAPHTEC midi LOGGER GL800 - Mount Extension Terminal Base Set (B-537)

Checks and Preparation
2-17
2.12 Mounting the Extension Terminal Base Set (B-537)
Mount the extension terminal base set as shown below.
CAUTION
Make sure the GL800’s power is OFF when mounting the extension terminals.
B-537 Set Contents
Extension Terminal Base Unit : 1 Extension Terminal Cable : 1
To Mount
(1) Remove the terminal unit mounted to the GL800 (refer to 2-11).
(2) Insert the tabs at the top of the terminal unit into the slots of the extension terminal base unit, and push in
the unit until the lock tabs at the bottom of the unit are securely locked.
(3) Connect the extension terminal cable to the extension terminal base unit.
* Press in the cable until it is securely locked.
(4) Connect the other end of the extension terminal cable to GL800.
* Press in the cable until it is securely locked.
(1) Insert tabs at the top of the terminal unit into the slots of
the extension terminal base unit.
(2) Press the unit in the direction shown until it is securely locked.
Extension terminal cable
Extension terminal cable