Settings and Measurement
3-15
3.4 Setting Menus
When you press the MENU key during Free Running, the following menu screens appear.
The menu screens are classified by the tab for each setting item.
(1) AMP settings
This menu is used to specify input signal-related settings.
AMP DATA TRIG USER I/F OTHR
Setting Selections available
Input Off, Voltage, Temperature, Humidity
Humidity: (CAUTION: The voltage is compulsorily set to
1V, and the scaling function set to ON. 0V→0%, 1V→100%)
Range Voltage: 20, 50, 100, 200, 500 mV
1, 2, 5, 10, 20, 50, 1-5 V
Temperature: TC-K, TC-J, TC-T, TC-R, TC-E, TC-B,TC-S, TC-N, TC-W,
PT100, JPT100, PT1000
Filter Off, 2, 5, 10, 20, 40
Function Off, On (effective when On has been selected)
Lower – Upper Settings
Unit Meas. Value (Upper/Lower)
EU Value (Upper/Lower)
Dec pt
Unit
Select
Misc. Span setting (Span All Settings)
Annotation setting
Zero voltage adjustment
Perform Auto Zero ADJ.
Reset Auto Zero ADJ.
[Zero point voltage value]
Logic/Pulse Off, Logic, Pulse
Logic
Filter: Off, On
Pulse
Input: Off, Revolution counts, Counts, Inst.
Filter: Off, On
Slope: H, L
Function: Off, On
Measured values settings
EU output value settings
Unit settings
EU (Scaling settings)
To Next Page
Loading...
