Settings and Measurement
3-5
(2) SPAN/TRACE/POSION
Switches the display in the digital display.
Used to change the settings related to waveform display during Free Running
(when stopped), data capture and data replay.
Pressing this key will switch displays as shown below.
Setting Procedure
1. Select the item you want to change (SPAN/TRACE/POSITION key).
2. Use the keys to switch the channels, and keys to change the setting values.
When ALL is set, setting values for CH1 is reflected on other channels.
* When CH1 is OFF, ALL cannot be set.
(3) TIME/DIV
Press the left/right key of the TIME/DIV key to change the time axis display width.
MONITOR SPAN POSITION TRACE
Displays digital values
(default status)
Allows changing of the span
value (waveform amplitude)
・Voltage time : 8 levels
・temperature time : 6 levels
Allows changing of the position
(waveform up/down position)
・Range can be changed in
units of 10%
Allows turning ON/OFF
of the waveform display
To Next Page
Loading...
