March 16, 2006 K2 Media Client Version 3.0.1.19 Release Notes 11
Upgrade software on Control Point PC
b. Under Event Viewer right-click the Application node and select Properties. The
System Properties dialog box opens.
c. If not already set, select
Overwrite events as needed. Click OK to close.
d. Under
Event Viewer right-click the System node and select Properties. The
System Properties dialog box opens.
e. If not already set, select
Overwrite events as needed. Click OK to close.
9. You can repeat this procedure as desired to upgrade K2 software on your other K2
Media Clients.
10.Continue with the next procedure “Upgrade software on Control Point PC”.
Upgrade software on Control Point PC
Before beginning this procedure, make sure that you have upgraded SNFS and K2
Media Client system software on K2 Media Clients, as instructed in the previous
procedures.
To upgrade Control Point software, do the following:
1. Insert the version 3.0.1.19 K2 System Software CD in the Control Point PC’s CD
drive.
To Next Page
Loading...
Need help?
General