142 K2 Storage System Instruction Manual July 3, 2007
Chapter 4 Installing the Level 3 Storage System
Assign chassis address on Expansion chassis
Every chassis must have a chassis address. The Level three RAID chassis address is
fixed at 0, so no configuration is required. However, if you have any L3 RAID
Expansion chassis you must set their chassis addresses as shown in the following
illustration. One each Expansion Chassis, set the same address on both Expansion
adapters, regardless of whether or not the second Expansion adapter is connected to a
second RAID controller.
L3 RAID
Chassis
Install L3 RAID Ethernet cabling as shown.
Ethernet Switch
Expansion Chassis have no direct Ethernet connections.
Ethernet cable
Connect to a
control port
To Next Page
Loading...
