22 LDX 86 HS/XS HiSpeed/XtremeSpeed HD camera User’s Guide (v1.0)
Chapter 2 - Installation
Do not attach a lens weighing more than 5 kg (11 lbs) to the camera without a proper lens
support.
When a new lens is fitted to the camera it may be necessary to carry out some adjustments to
optimize its use, for example, back focus or shading. For more information about these
adjustments refer to the lens manufacturer’s documentation.
Always mount the dust protection cap when the lens is not connected to the camera.
2.2 EC 270 EyeCatcher viewfinder
2.2.1 Mounting the viewfinder
To mount the viewfinder proceed as follows:
• Loosen locking ring (2) of viewfinder support bracket (1) at the front of the camera
handgrip. (As seen from the rear of the camera, turning the locking ring counterclockwise
moves it towards the handgrip.)
• Push the locking pin (3) in and slide the viewfinder onto the viewfinder support bracket (1).
• Tighten the locking ring (2) by turning it clockwise (as seen from rear) so that the
viewfinder is mounted securely to the support.
To improve the comfort of the skin contact when using the viewfinder, fit the eye piece cover
to the rubber eyepiece. Spare covers are available via your Grass Valley representative.
• Connect the viewfinder cable to the viewfinder socket (1) at the top right of the camera.
3
1
2
To Next Page
Loading...
