219Program description - Dual mixers
Diff.
Mix
er1
Mixer2
8
Mixer3
Mixer4
??
??
??
??
??
??
0%
0%
0%
RU
+75%
Dual mixer
When a rudder command is given, the second servo
connected to output 8 follows suit. (With this type of
programming, differential travel can be configured
for the rudders.) In this case, too, trim from the rud-
der stick affects both servos. If the rudders are also
required to deflect outwards when the airbrakes are
activated, then you should assign the C1 stick (trans-
mitter control 1) to input 8 on the »Control adjust«“
menu. Afterwards, change to the “Offset” column then
modify the offset value until both rudders are again in
their neutral positions. It may be necessary to “play” a
bit with the offset and travel adjustments.
To Next Page
Loading...
