55Receiver initialization
out for just on three seconds, before only the red LED
continues to flash. Release the button as soon as the
LEDs go out.
At the transmitter and receiver it is now possible to
carry out a Binding procedure immediately.
If the reset is done on a bound receiver and the cor-
responding model memory is active in the powered
on transmitter, the LED will illuminate in green after
2 or 3 seconds as an indication that the transmitter/
receiver system is again ready for operation.
Please note the following:
A receiver RESET will cause ALL receiver set-
tings, except for binding information, to return to
their factory settings.
Therefore if a RESET is triggered unintentionally,
any custom settings that had been present in the
receiver before the reset will have to be estab-
lished again by way of the »Telemetry« menu.
A deliberate RESET is recommended, especially
if a receiver is to be “transferred” into another
model. This is a rather simple method to eliminate
settings which are no longer applicable.
To Next Page
Loading...
Need help?
General
