EN - 29
7. Remove PTO belt.
Install PTO Belt
1. Install PTO belt around clutch sheave at
rear of unit.
See Figure 41 and Figure 42.
2. Route PTO belt around spindle pulleys.
3. Align belt with idler pulleys.
See Figure 43 and Figure 44.
4. Reinstall support bracket and stepped
spacer onto PTO idler.
5. Secure support bracket to PTO idler with
original hardware.
IMPORTANT: Make sure belts are correctly
aligned in pulleys.
6. Reinstall spring hook onto anchor bolt.
Figure 39
1. Spring
2. Support Bracket
3. PTO Belt
1
2
3
Model 988171
Figure 40
1. Spring
2. Anchor Bolt
3. Support Bracket
4. PTO Belt
1
2
4
3
Models 988172, 988173, 988174
Figure 42
Models 988172, 988173, 988174
To Next Page