Need help?Do you have a question about the GRAVOGRAPH M10 JEWEL and is the answer not in the manual?
General| Brand | GRAVOGRAPH |
|---|---|
| Model | M10 JEWEL |
| Category | Printer |
| Language | English |
Details EC conformity, electrical, machine, and EMC standards for safe operation.
Specifies Class 1 electrical safety and mandatory connection to a neutral socket.
Overview of the machine, its intended use, and critical contra-indications.
Covers unpacking stages, package contents, internal and external components.
Describes rear view, connection ports, and functions of the machine's control panel.
Guidance on placing the machine on a stable surface and ensuring safe electrical connection.
Instructions for connecting the machine to a PC via USB and troubleshooting connectivity.
Details machine power on/off, troubleshooting, and system requirements for software.
Steps to start engraving, including software setup and montage preparation.
Detailed steps for mounting and engraving rings and bracelets inside the machine.
Detailed steps for mounting and engraving rings and bracelets outside the machine.
Procedures for adjusting machine reference points on X, Y, and Z axes for accurate engraving.
Provides physical, engraving, electrical, connection, and software characteristics of the machine.
Guide to installing software, drivers, setting up connections, and legal terms.
To Next Page
