HackRF
12.3.2 Software Configuration
I’m using libusb-1.0.9.
Install OpenOCD-0.6.0 dev
# Cloned at hash a21affa42906f55311ec047782a427fcbcb98994
git clone git://openocd.git.sourceforge.net/gitroot/openocd/openocd
cd openocd
./bootstrap
./configure --enable-stlink --enable-buspirate --enable-jlink --enable-maintainer-mode
make
sudo make install
OpenOCD configuration files
openocd.cfg
#debug_level 3
source [find interface/stlink-v2.cfg]
source ./lpc4350.cfg
lpc4350.cfg
set _CHIPNAME lpc4350
set _M0_CPUTAPID 0x4ba00477
set _M4_SWDTAPID 0x2ba01477
set _M0_TAPID 0x0BA01477
set _TRANSPORT stlink_swd
transport select $_TRANSPORT
stlink newtap $_CHIPNAME m4 -expected-id $_M4_SWDTAPID
stlink newtap $_CHIPNAME m0 -expected-id $_M0_TAPID
target create $_CHIPNAME.m4 stm32_stlink -chain-position $_CHIPNAME.m4
#target create $_CHIPNAME.m0 stm32_stlink -chain-position $_CHIPNAME.m0
target.xml, nabbed from an OpenOCD mailing list thread, to fix a communication problem between GDB and newer
OpenOCD builds.
<?xml version="1.0"?>
<!DOCTYPE target SYSTEM "gdb-target.dtd">
<target>
<feature name="org.gnu.gdb.arm.core">
<reg name="r0" bitsize="32" type="uint32"/>
<reg name="r1" bitsize="32" type="uint32"/>
<reg name="r2" bitsize="32" type="uint32"/>
<reg name="r3" bitsize="32" type="uint32"/>
<reg name="r4" bitsize="32" type="uint32"/>
<reg name="r5" bitsize="32" type="uint32"/>
<reg name="r6" bitsize="32" type="uint32"/>
(continues on next page)
38 Chapter 12. LPC43xx Debugging
To Next Page
Loading...