Section 7
Using Bluetooth 127
Using Your Jitterbug With Your Bluetooth Headset
There are three steps to set up your Jitterbug with a Bluetooth headset:
1. Turning on the Bluetooth feature on your Jitterbug.
2. Setting your Bluetooth headset to Pairing Mode.
3. Setting your Jitterbug to Pairing Mode.
Turning The Bluetooth Feature On Your Jitterbug On And Off
Turning The Bluetooth Feature On
The following procedure is applicable to all Bluetooth compatible devices. You
must have your Jitterbug set to “Bluetooth ON” to use any Bluetooth device.
To Next Page
Loading...
