Air Handlers
6
immediate or potential hazards. It is the owner’s responsibility to read and comply
with all safety information and instructions accompanying these symbols. Failure to
heed safety information increases the risk of serious personal injury or death,
property damage and/or product damage.
Immediate hazards which will result in property damage, product
damage, severe personal injury or death.
Hazards or unsafe practices could result in property damage,
product damage, severe personal injury or death.
Hazards or unsafe practices which may result in property damage,
product damage, severe personal injury or death.
Before serving or installing this equipment. The electrical power
to this unit must be in the “off ” position. Caution, more than one disconnect may
exist. Failure to observe this warning may result in an electrical shock that can
cause personal injury or death.
The United States Environmental Protection Agency (“EPA”) has issued various
regulations regarding the introduction and disposal of refrigerants introduced into
this unit. Failure to follow these regulations may harm the environment and can lead
to the imposition of substantial fines. These regulations may vary due to the
passage of laws. A certified technician must perform the installation and service of
this product. Should questions arise, contact your local EPA office.
Due to high system pressure and electrical shock in potential, installation and
service work can be dangerous. Only trained and qualified persons are permitted to
install or service this equipment. Observe all warnings contained in this manual and
labels/tags attached to the equipment.
This product is factory shipped for use with a 208/230V-1Ph-60Hz electrical
power supply. This air handler must not be reconfigured to operate with any other
power supply.
The unit must have an uninterrupted, unbroken electric grounding to minimize
the possibility of personal injury if an electric fault occurs. The electric grounding
To Next Page
Loading...
Need help?
General
