Gree FP-22LM/D-K - Page 33

30
Unit Installation
Insert user-provided M10 expansion bolts into the holes on the wall and fix them as shown in the
picture below.
Expansion bolt
Open the cover. Loosen three screws and lift the decorated panels (on left or right side) 1cm above
and remove them in a horizontal way.
Open the cover
Loosen screws
Lift the decorated panels
(on left or right side) 1cm above
After
Before
Remove it in
Suspension hole
Suspension hole
a horizontal way
Let the suspension holes t the expansion bolts so that the unit can be hung.
Regulate the unit position to slightly tilt the drain pipe and tighten bolts with nuts.
Use a level to indicate that the unit is ush with the ground.
Suspension hole
Suspension hole