39
Unit Installation
(4) Loosen screws to take away the panels.
(5) Press clasps hard to take away volute
casings.
(6) Use an inner hexagonal spanner to loosen
screw to take out fan blades from the motor.
(7) Loosen two screws of the electric box to remove
it. Take out connecting tabs between terminal
blocks and capacitors. Cut off xing clamps
to take away motor wires. Loosen set screws
of the motor to remove bar clasps and loops.
Loosen its screws of earth lines to take away
the motor.
To Next Page
Loading...
