CONTROL
26
1.1.1 Guide for operation-general operation
(1) Press ON/OFF button to start the unit after poweringthe main unit on.(Note: Power the unit on
every time,the big-guide louver and small-guide louver will beclosed firstly.)
(2) Press MODE button to select desired running mode.
(3) Press +/ - button to set the desired temperature.(It is unnecessary to set the temperature at AUTO
mode)
(4) Press FAN button to set fan speed, the AUTO FAN,LOW, MID or HIGH could be selected.
(5) Press and button to set swing mode.
1.1.2 Guide for operation-optional operation
(1) Press SLEEP button, set the sleep mode.
(2) Press TIMER button, then press +/- button,
(3) to set the cheduled timer on or timer off.
(4) Press light button to control displayer light on or off.
(5) Press X-FAN button to set X-FAN function on or off.
(6) Press turbo button to set this function on or off.
1.1.3 Introduction for special function
(1) About X-FAN function
This function indicates that moisture on evaporator of indoor unit will be blowed after the unit About
X-FAN functionis stopped to avoid mould.
Having set X-FAN function on: After turning off the unit by pressing ON/OFF buttonindoor fan will
continue running for about 10 min. at low speed. In this period, press X-FAN button to stop indoor fan
directly.2. Having set X-FAN function off: After turning off the unit by pressing ON/OFF button, the
complete unit will be off directly.
(2) About AUTO RUN
When AUTO RUN mode is selected, the setting temperature will not be displayed on the LCD, the unit
To Next Page
Loading...
Need help?
General
