Unit Control
★
At the function setting page with the unit turned off, by touching ―
Fast hot water
‖, the display panel
will go to the corresponding setting page, where desired option can be selected. Then by pressing ―
OK
‖
this setting will be saved and the display panel will back to the function setting page.
[Notes]
：
●This function can be set to ―
On
‖ only when the water tank is available. When the water tank is
unavailable, this function will be reserved.
●It will be memorized upon power failure.
3.2.2.3 Cool + hot water
[Operation Instructions]
★
At the function setting page with the unit turned off, by touching ―
Cool + hot water
‖, the display
panel will go to the corresponding setting page, where desired option can be selected. Then by
pressing ―
OK
‖ this setting will be saved and the display panel will back to the function setting page.
[Notes]
●When the water tank is unavailable, it will be reserved; when it is unavailable, the default priority will
be given to ―
How water
‖.
●It will be memorized upon power failure.
3.2.2.4 Heat + hot water
[Operation Instructions]
★
At the function setting page with the unit turned off, by touching ―
Heat + hot water
‖, the display panel
will go to the corresponding setting page, where desired option can be selected. Then by pressing
―
OK
‖ this setting will be saved and the display panel will back to the function setting page.
[Notes]
●When the water tank is unavailable, it will be reserved; when it is unavailable, the default priority will
be given to ―
How water
‖.
●It will be memorized upon power failure.
3.2.2.5 Quiet Mode
[Operation Instructions]
★
At the function setting page with the unit turned off, by touching ―
Quiet mode
‖, there will be a choice
box, where ―Quiet mode‖ can be set to ―On‖, ―Off‖, or ―Timer‖.
★
When it is set to ―
Timer
‖, it is also required to set the ―
Start timer
‖ and ―
End timer
‖. Unless otherwise
stated, otherwise time setting is all the same.
Timer for Quite Mode
★
3. This setting will be saved by touching the corner at the upper right corner.
[Notes]
●It can be set under both ON and OFF statuses, but will work only when the main unit is turned on.
To Next Page
Loading...
