Unit Control
★ At the time period setting page, each time period can be set to ―Valid‖ or ―Invalid‖.
★ The option ―Mode‖ is used to preset the mode; ―WOT-Heat‖ is used to set the leaving cold/hot water
temperature; ―Start timer‖ / ―End timer‖ is used to for time setting. After that, by touching the ―Save‖
icon, all settings will be saved.
[Notes]
：
● When ―
Preset mode
‖ has been set to ―
Hot water
‖ and ―
Water tank
‖ is to set to ―
Without
‖, the preset
―
Hot water
‖ mode will be automatically switched to ―
Heat
‖.
● When ―
Weekly timer
‖ and ―
Preset mode
‖ both have been set, priority will be given to the latter.
● When the water tank is available, the preset mode can be ―
Heat
‖, ―
Cool
‖, or ―
Hot water
‖; however,
when the water tank is unavailable, the preset mode can only be ―
Heat
‖ or ―
Cool
‖.
● ―Start timer‖ should be earlier than ―End timer‖, otherwise a dialog will pop up, saying ―time setting
wrong‖.
● The setting for ―Preset mode‖ will works until it has been canceled manually.
● When ―Start timer‖ is reached, the unit will perform the preset mode. In this case, mode and
temperature setting are still allowed but will not be saved to the preset mode. When ―End timer‖ is
reached, the unit will perform OFF operation.
●This function will be memorized upon power failure.
3.2.2.15 Error Reset
[Operation Instructions]
★
At the function setting page, by touching ―
Error reset
‖, a choice box will pop up, where by touching
―
OK
‖ the error will be reset and by touching ―
Cancel
‖ the error will not be reset.
To Next Page
Loading...
