72
DC Inverter Multi VRF System II
Service Manual
Removal operation for blade
Remark: Before removing the motor, please make sure that the unit is disconnected with the power.
Process Photo Operation Instruction
1. Remove grille
● Loose screws xing the panel with screwdriver
● Then remove the grille
2. Remove
blade
● Loosen nuts xing the blade with wrench
● Then remove the blade and put it on the oor
atly
3. Remove
motor
● Loose screws xing the motor with screwdriver
● then remove the power cord of motor
● Take out the damaged motor
4. Install motor
● Replace the motor, tighten screws with
screwdriver and then connect teh power cord of
motor
To Next Page
Loading...
