Owner’s Manual
15
(1) Before installation, please cut off the power supply of
indoor unit, it is not allowed to operate with power supply;
(2) Pull out the 2-core twisted pair inside the installation hole
in the wall, and thread the wire through the hole in the
back of soleplate of wired controller;
(3) Stick the soleplate of wired controller on the wall, and use
Self-tapping Screw ST3.9×25 MA or screw M4×25 to fix
the soleplate with the installation hole of wall;
(4) Connect the 2-core twisted pair to wiring terminal H1 and
H2, and then tighten the screw;
(5) Arrange the wires in the back of panel, and then buckle
the panel of wired controller with the soleplate of wired
controller.
4.1.5 Disassembly
Fig. 4.11 Disassembly of wired controller
To Next Page
Loading...
