Owner’s Manual
34
to the model of indoor unit.
② When the wired controller controls VRF unit and the system
mode priority is the master-slave mode, only the master indoor
unit can set the auto mode.
③ Under Auto mode, if the indoor unit is running under Cooling, the
icons “ ” and “ ” will light up; if the indoor unit is running
under Heating, the icons “ ” and “ ” will light up.
5.3 Temperature Setting
Press “+” or “-” button under on status to increase or decrease
set temperature by 0.5°C/1°C or 1°F; hold “+” or “-” button to
increase or decrease set temperature by 0.5°C/1°C or 1°F every
0.3s. Please refer to 4.2.3 Parameter Setting for the setting method
of the temperature setting interval in Celsius.
In Dry mode, when temperature is 16°C or 61°F, continuously
press “-” button twice to decrease temperature to 12°C or 54°F
(when save function is activated, the temperature in Dry mode can’t
be adjusted to 12°C or 54°F).
When the control method under Dry mode is humidity control,
press "+" or "-" button to adjust the set humidity at 5% intervals. The
humidity setting range is 45%~75%, and the default value is 65%.
The humidity control method under Dry mode can only be set for the
unit with this function. Please refer to 4.2.3 Parameter Setting for the
setting method.
NOTES:
① Only when the wired controller controls U-match indoor units, can
To Next Page
Loading...
