Owner’s Manual
45
Start up Save function for Heating: When the unit is off,
simultaneously press “TIMER” and “+” buttons for 5s, the buzzer will
give out a sound and then unit will enter into Save setting mode. “ ”
icon is blinking. Mode icon is on. Press “MODE” button to switch to
Heating or 3D Heating or Space Heating mode. Press “+” or “-”
button to adjust the temperature limit for Save function. Press
“ENTER” button to start up Save function.
After starting up save function, it will display “ ” icon for all
modes under on and off status.
Cancel save function:
When the unit is off, press “TIMER” and “+” buttons for 5s to
enter into save setting, press “ENTER” button to cancel Save
function of all modes.
NOTE
:
When the Save function is turned on and then set temperature
exceeds the limit value for Save function, “ ” icon blinks three times
and then buzzer will give out two sounds successively.
5.11 Filter Clean Reminder Setting
Filter Clean Reminder Function: Unit will remember its own
operating time. When the setting time is up, this function will remind
you to clean the filer. A dirty filter will result in bad heating and
cooling performance, abnormal protection, bacteria gathering, etc.
Turn on Filter Clean Reminder Function: When unit is on, press
“FUNCTION” button and select Filter Clean Reminder. “ ” icon will
blink. Press “+” or “-” button to adjust the cleaning level, of which the
To Next Page
Loading...
