Service Manual
Installation and Maintenance
71
Steps
Procedure
Screws
Flow Guide Loop
Screws
Screws
13.Remove Flow Guide Loop
Remove 3 screw on flow guide loop
and chassis, and three screws on
condenser, and then remove the flow
guide loop.
Condenser
4-way valve
Evaporator
Compressor
14.Remove condenser and evaporator
Remove the 3 screws fixing the
Evaporator; unsolder the welding joints
of the suction pipe, discharge pipe,
compressor, 4-way valve with the
condenser and evaporator, and then
remove the condenser and evaporator.
(before unsoldering, discharge the
refrigerant in the pipeline completely)
To Next Page
Loading...
