Greenlee 1813 - Troubleshooting

Greenlee / A Textron Company 34 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
881 and 881CT Cam Track
®
Hydraulic Benders
Troubleshooting (cont’d)
Wrinkling of IMC or rigid. Follow bar is in backwards. Remove follow bar and insert end
marked START toward saddle.
Side creasing of IMC or rigid. Conduit is not level (when bending Level the conduit.
on floor).
Follow bar not centered on roller at Center the follow bar on the roller.
start of bend.
Won’t bend IMC or rigid. Shoe pin in wrong position. Move shoe pin to hole marked
IMC/RIGID.
Follow bar is in backwards. Remove follow bar and insert end
marked START toward saddle.
Ram will not advance. Pump does not have enough oil. Add oil. See instructions supplied with
the pump.
Pump vent is closed. Open the pump vent.
Hose couplings not fully tightened. Tighten the hose couplings.
Excessive voltage drop from long Use a shorter or heavier extension cord.
extension cord.
PROBLEM PROBABLE CAUSE PROBABLE REMEDY