GREENLINE 33 - SELECTING ELECTRIC or DIESEL DRIVE

Greenline 33 52
SELECTING ELECTRIC or DIESEL DRIVE
ELECTRIC DRIVE
Make sure that the engine throttle lever is in neutral
position.
Set the Hybrid switch to ELECTRIC.
Turn the DIESEL engine key to the »ON« position.
-GREEN LIGHT on the panel switches on.
Wait for cca 5 seconds for the system to set to the
electric drive.
Ready to sail
Switching the Electric drive OFF –Turn the DIESEL
engine key to the »OFF«
position.
GREEN LIGHT on the panel switches off
DIESEL DRIVE
Make sure that the engine throttle lever is in neutral
position.
Set the Hybrid switch to DIESEL.
Turn the DIESEL engine key to the »ON« position.
- YELLOW LIGHT on the panel switches on.
-»NEUTRAL« should appear on the VW control
display (if not, check the position of the throttle lever).
Turn the DIESEL engine key to the »START« position
to start the engine.
Ready to sail.
Switching the Diesel drive OFF – Turn the DIESEL
engine key to the »OFF«
position.
YELLOW LIGHT on the panel switches off
There are also important monitors for the hybrid drive parameters. For details see Hybrid monitoring
(chapter 3.) propulsion/generator and Battery monitoring – BMV.
CAUTION!
If switching from electro to diesel (step 1) after step 2: first put the
throttle lever in neutral, turn the hybrid switch to diesel and wait for 5
seconds before starting the diesel engine, allowing the clutch to
reconnect the diesel engine.
CAUTION!
In electric drive the alternator is not turning. You have to turn 12 V
charger ON to supply continuous power to hybrid cooling pump.
(Inverter ON, F39 ON, F40 ON)