Greenline 33 73
SHORE POWER
Shore power can be used in the marina. Just connect shore power cable to a marine outlet, (see picture 28)
and turn on fuses F38-F42 (see chapter »Power sources«). It is recommended to fully charge the batteries in
the marina with shore power!
Picture 26: Shore power cable (230V input) and main fuse
Shore power cable (230V input), fuse F38 under cockpit seat, stbd side.
Disconnect shore-power connection when the system is not in use.
Do not allow the shore-power cable end to hang in the water. An
electrical field can be caused which can cause injury or death to nearby
swimmers.
Turn off craft’s shore-power connection switch (F38) before connecting
or disconnecting shore-power cable.
Connect shore-power cable to craft’s inlet before connecting to shore-
power source.
Disconnect shore-power cable at shore-power source first.
Close shore-power inlet cover (or cockpit seat) tightly.
To Next Page
Loading...
