GREENLINE 33 - Page 66

Greenline 33 59
INVERTER – light indicators
BATTERY CHARGER – light indicators
The inverter is on and supplies
power to the load.
The nominal output of the
inverter is exceeded. The
“overload” LED flashes
Reduce electric consumption !!!
The inverter is switched off due
to overload or short circuit.
Reduce electric consumption !!!
The battery is almost fully
exhausted.
Charge the battery.
The inverter has switched off
due to low battery voltage.
Charge the battery.
The internal temperature is
reaching a critical level.
The inverter has switched off
due to the electronics
temperature being too high.
The inverter switched off due to
excess ripple voltage on the
battery terminals
The AC input voltage is
switched through and the
charger operates in bulk
mode.
The mains voltage is switched
through and the charger is on.
The set absorption voltage,
however, has not yet been
reached. (BatterySafe mode)
The mains voltage is
switched
through and the charger
operates in absorption
mode.
The mains voltage is switched
through and the charger
operates in float mode.