To Reactivate Commissioning Mode
Press any button to activate the panel. The current fan setup / status
should be shown via the panel lights.
To enter the commissioning mode press and hold [-/+] buttons
simultaneously for approximately 3 seconds until the Bathroom &
Kitchen lights flash – airflow settings from previous commissioning
should be recalled, these can now be re-adjusted.
Note: To ‘master reset’ press and hold [-/+] buttons simultaneously for
approximately 10 seconds until all lights flash to indicate the fan has
been reset to factory settings and then revert to both room selection
lights at start of commissioning mode.
Performance Graph Airflow Characteristics.
15
2.9.4
2.9.5
Note: The Unity CV2GIP / CV2SVGIP will automatically compensate for
fluctuations in back pressure, to meet Building Regulation requirements.
To Next Page
Loading...
Need help?
General
