GreenWorks PSPH40B00 - Remove the Saw Head

.;
ASSEMBLY
• Align the groove on the outside of the coupling end of the extension tube (9) with the tongue
on the inside of the coupling end of the saw head (8).
• Push the saw head (8) onto the extension tube (9).
• Slide the collar upwards and rotate it counterclockwise until it is fully tightened.
2 7 ',+,9
Periodically check the couplers to ensure that they are tightened securely.
'(:#\(!")(!472!)(78!V&+9LXW
If the extension tube (9) is tted, the saw head must be removed rst.
• To remove the saw head (8), rest the handle (7) on the ground, loosen the collar and take off
the saw head.
&+9LX
7
8
9