The instructions below are given for a typi-
cal heavy-duty shop floor made of 6" thick con-
crete. Also, anchor studs may be substituted for
lag bolts, but they will stick out of the floor if you
decide to move your machine at a later point.
Tools Needed Qty
Hardware Needed Qty
To mount the resaw machine to the floor:
1.
2.
3.
4.
5.
Mounting Resaw to
the Floor
Mounting the
Conveyor Belt
Tools Needed Qty
Hardware Needed Qty
To install the conveyor belt onto the resaw:
1.
2.
Figure 8
The conveyor belt is very
heavy. Seek assistance
or use power equipment
to mount the conveyor
belt.
3.
Figure 8
Figure 8.
To Next Page
Loading...
Need help?
General
