Resawing
8.
If a second person is
receiving the workpieces, use the return roll-
ers to send them back to the person on the
infeed side.
Figure 34.
Figure 33.
5.
Figure 33.
NOTICE
Always de-tension blade after use. Bandsaw
blades will last longer and stretch less if de-
tensioned after each use.
DO NOT cut slices thinner than
1
⁄4" off of
the bottom of the stock. Attempting to cut
thin slices off of the bottom may cause the
blade to cut into the conveyor belt.
To perform a resawing operation:
1.
Installing the
Blade page 22
2.
Six
rotations of the handwheel raises the blade
approximately
1
/4".
3.
4.
Figure 33
6.
7.
Figure 34
NOTICE
Running the conveyor too fast can push the
blade into the support bearing, grooving the
bearing and causing blade breakage.
To Next Page
Loading...
Need help?
General
