2.
Note: The thickness stop should only be
used for approximate measurements. If pre-
cise workpiece thicknesses are needed, use
calipers to ensure your workpieces meet your
standards.
Figure 16.
.
Example:
Note: The cutterhead elevation scale does not
provide a precise measurement and should only
be used for approximate measurements. If precise
workpiece thicknesses are needed, use calipers
to ensure your workpieces meet your standards.
Figure 17.
Cutterhead Elevation Scale
Figure 17
Thickness Stop
To use the thickness stop:
1.
Figure 16
Elevation Lock
Figure 18
Figure 18. Elevation lock lever.
To Next Page
Loading...
Need help?
General
