Grizzly g0703 - Power Connection and Disconnection; Connecting and Disconnecting Power



NOTICE
The Model G0703/G0703P is prewired for
110V. If you plan to operate the machine at
220V, the motor must be rewired (see Page
12) and a 220V switch must be installed.
Power Connection

After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.
Connecting Power
Figure 28. Connecting power.
1. TurnthemachinepowerswitchOFF.
2. Insert the power cord plug into a matching
power supply receptacle. The machine is
nowconnectedtothepowersource.
Disconnecting Power
Figure 29. Disconnecting power.
1. TurnthemachinepowerswitchOFF.
2. Graspthemoldedplugandpullitcompletely
outofthereceptacle.Donotpullbythecord
asthismaydamagethewiresinside.